You can always check which stations are connected to the reflector by visiting and looking for nodes connected to REF 2. At any given time there are usually 6 to 10 repeaters around the world interconnected via this Reflector. A reflector is a Linux computer that is not connected to any radio but rather sits on lots of internet bandwidth capable of allowing many repeaters to be inter-connected together by streaming the received audio back to all other connected stations. While Direct Connect is preferred for a city to city chat, the most common type of connection in use today is via the Denver Reflector (Ref2). While repeaters "A" and "B" are connected, anyone attempting to connect with either node will be told by a recording that - "The node you are calling is currently connected to callsign" however all local traffic on each repeater will be heard on the other repeater as well. With this type of link the two nodes are interconnected and no other IRLP connections are possible. Direct one-to-one or, one-to-many via a Reflector.ĭirect connect is just like it sounds where repeater (node) "A" connects direct with node "B". There are two connection modes for an IRLP connection. These notes are only a guideline and at no time should take precedence over the wishes of your local node sponsor. The following guidelines may differ from those provided by your local node operator. This work in progress can serve as a guideline for those wishing to use their local IRLP enabled repeater node. Many repeaters around the world that were next to empty are now alive and well with radio amateurs now speaking with other hams around the world.Īs with any new technology, it does take some time to adopt to operating procedures that differ from conventional FM repeater use. Thanks to IRLP, Amateur Radio is receiving a new breath of life through his Internet Radio Linking Project. IRLP Node codes and locations Sorted by: Province/State IRLP Node codes and locations Sorted by: Number Here are the important links needed to operate the IRLP: Then give your callsign, and say that you are clear the IRLP.
AUDIOTEST IRLP CODE
Then enter the code to bring down the link.
AUDIOTEST IRLP HOW TO
How To Access The Repeater IRLP Link System Most important, wait a few seconds before you transmit and then wait a few more seconds before you talk. Of course there is a lot more to learn about irlp before you start connecting to nodes and making friends all around the world. Which will record 10 seconds of your audio and then play it back again. The simplest node to try is the echo reflector You will not hear anything from the node until it